DISH Network HOME NETWORK Manuale Utente

Once the receiver has been connected to the home network, use these steps to set up and verify the 
receiver’s Internet connection.

Using the DISH Network remote control for the receiver that is connected to the home network, 
access the Network Setup screen by pressing MENU, selecting System Setup, Installation, 
Broadband Setup

, then Network Setup. Verify the IP address is populated (not all 0s). If the IP 

address is all 0s, select Reset Connection. An Attention 875 message will display briefly, then 
you will return to the Network Setup screen.

Verify the Connection Status on the Network Setup screen shows Connected Online, and that 
the IP address does not show all 0s. If the IP address shows all 0s or the Connection Status shows 
Not Connected, refer to Troubleshooting on page 12.

Select Done to exit the Network Setup screen.