ADC Campus-REX2 RS Manuale Utente
Chapter 3 - Configuring the REX2
32
Campus-REX2 RS Interface Card User Manual
Configuring Bridge Features
This section provides procedures for configuring bridging features such as
filter aging and Spanning Tree Protocol. And, although a bridge does not
require an IP address, you will set up IP configuration for the unit so that you
can access it for management using SNMP, telnet, or FTP.
filter aging and Spanning Tree Protocol. And, although a bridge does not
require an IP address, you will set up IP configuration for the unit so that you
can access it for management using SNMP, telnet, or FTP.
1
To configure the bridge, from the REX2 Configuration and Status screen
type
type
then press
. The Bridge Configuration screen is displayed.
The bridge and Address Resolution Protocol (ARP) tables are
dynamically built and can be accessed from this screen. See
dynamically built and can be accessed from this screen. See
and
for more information.
2
To set the bridge filter age, type
then press
. Enter the filter age
time in seconds from 10 to 100000 (300 is the default) at the prompt:
Enter New Bridge Filter Age in Seconds : 1000
The bridge filter age indicates the time in seconds in which a MAC
address entry is eliminated from the bridging table if it is not relearned.
address entry is eliminated from the bridging table if it is not relearned.
3
.
4
ENTER
Jul 07, 2003
ADC TELECOMMUNICATIONS, CAMPUS RS, Version 5.1 08:19:34
Local Unit ID:
Local I/F:
REX2
Remote Unit ID:
Remote I/F: REX2
Circuit ID:
BRIDGE CONFIGURATION
1) Bridge Filter Age (sec):
300
(10 - 100000)
2) SPANNING TREE CONFIGURATION
3) BRIDGE TABLE
4) ARP TABLE
UNIT IP
5) IP Configuration:
Static
(Static, DHCP Client)
6) IP Address:
192.168.
1.
1
Subnet Mask:
255.255.255.
0
7) Default Gateway:
0
.0
.0
.0
(R)eturn
(M)ain Menu
ENTER CHOICE>
1
ENTER