Lennox Hearth P/N 775 024M Rev. C Manuale Utente

Page 6 

REMOVE APPLIANCE FROM PALLET 
1.  After removing the packaging from the stove, lift the 

hopper lid, and remove any pre-packaged items 
that were shipped in the hopper.  Also open the 
door assembly and remove any pre-packaged 
items. 

2.  Using a 3/8” socket or open end wrench, remove 

the four bolts from the leg bottoms that secure the 
stove to the wooden pallet. 

 

 

Remove the 4 bolts. 

 
INSTALL DOOR HANDLE ONTO DOOR ASSEMBLY 
 
1.  Remove door handle from packaging and attach to 

door as illustrated below. 

 

 

 

 

MANUFACTURED (MOBILE) HOME INSTALLATION  
Model – Cascade 
In addition to the standard installation instructions, the 
following instructions may be required by local, state or 
federal building codes: 
•  Stove must be permanently bolted to the floor.  
•  An outside air inlet must be provided for combustion 

and be unrestricted while unit is in use. Use a galva-
nized or stainless steel pipe for the duct. The mini-
mum size for the duct shall be not less than 50% of 
the cross sectional area of the flue outlet (the outside 
air inlet on the stove is 2" diameter). 

•  Stove must be permanently electrically grounded to 

the steel chassis of the home. The location selected 
for ground attachment to the stove must be dedicated 
for this purpose.  

•  See pages 7 through 13 for additional information on 

venting requirements. 

•  Do not install appliance in a sleeping room. 
•  The structural integrity of the manufactured home 

floor, walls, ceiling and roof must be maintained. 

 
NOTE: The grounding of this product, at installation, 
must comply with NFPA-70 standards, CSA C22.1 in 
Canada, as well as any local codes. 

 

 
 

PALLET 

DOOR 
ASSEMBLY

 

FRONT BACK