Apex Digital DT502 Manuale Utente

Connect antenna wire to RF ANTENNA IN on the rear of the 
DT502. Connect the supplied coaxial cable wire from the 
CH 3/4 terminal (RF Out) to RF ANTENNA INPUT on the rear 
of your TV.

To view, tune Ch 3 or 4 on your TV, choose the channel that 
does not have an active or strong signal. Slide the CH 3/4 
switch located on the rear of the DT502.

 

RF Coaxial cable 

to your TV

Over-the-air Antenna

ANTENNA IN

TV OUT

The DT502 is equipped with a shared analog pass-through and it provides a way for you to receive analog 
broadcast without using a splitter. The TV Out (RF Out) serves both as the Channel 3/4 output and as the 
analog pass-through output. The output from this connector depends on if the unit is On (active) or it is in 
Standby (sleep) mode.

This table illustrates the different output from the RF Out connector.

 

Power Indicator 

Light 

TV Out Mode 

(RF Out) 

Standby  

(Sleep) 

On 

(Active) 

Actual Output 

Red 

Analog Pass-through 

Green 

NTSC CH 3/4 

RF signal with analog 

programming from analog broadcast 

stations 

Analog RF signal in channel 3 or 4  

converted from digital programming  

contents broadcasted by digital  

stations 

  

  
1. Make sure the converter box is in Standby mode – the power 
indicator light should be red; otherwise, press the Power button 
on the converter’s remote control.  
 
2. This step only need to perform once after connection and it is 
only require if you did not scan the local channel before – scan 
analog channels by following the instruction of your TV. It is the 
same as connecting your TV directly with an antenna.  
 
3.  You  must  use  the  remote  control  from  your  TV  to  change 
channels. 

9