Baby Trend PY81988 Manuale Utente

 Copyright © 2009 - 2010, Baby Trend Inc., All Rights Reserved.

 Copyright © 2009 - 2010, Baby Trend Inc., All Rights Reserved.

 

IMPORTANT:  Test each top rail by pushing 

down slightly to confirm each is rigid and 

locked securely in place before use. (Fig. 4)

5. Place the Mattress on the floor of the Playard 

with the padded side facing up. (Fig. 5)

6. Insert the three (3) Velcro® straps located on 

the underside of the Mattress through the slots 

in the floor of each end of the Playard (Fig. 

6).  Fasten the hook and loop straps to the 

underside of the Playard floor to prevent the 

Mattress from moving. (Fig. 7)

IMPORTANT:  The handle located in the 

center of the Playard floor MUST remain raised 

(Approx. 45.7 cm or 18 inches) while locking 

the side rails in place.  If the center is not raised 

the rails will NOT lock.

    

 

If you experience difficulty and one side of the 

rail will lock but the other side will not then, 

unlock the rail by squeezing the release in the 

center and try again.  If you still have difficulty, 

contact our Customer Service Center at  

1-800-328-7363 or visit us online at  

www.babytrend.com.

7. To operate the brakes on the Wheels, press 

downward on the brake levers.  To release, lift 

upward on the lever. (Fig. 8)

To use as a bassinet, skip to page 8 for bassinet 

installation instructions.

 

1. Release the  three (3) Velcro® straps holding 

the Mattress from underneath the Playard floor 

or the Bassinet and set the mattress aside.

2. Do not unlock top rails yet, center of floor must 

be raised before top rails will unlock.

3. Rotate the center handle counter-clockwise 

90 degrees and raise the center as high as the 

top rails (Fig. 9).  Gather the Legs and Wheels 

together towards the center as close as possible 

so that they nearly touch.  

4. Locate the rail latch release in the center and 

bottom side of each rail.  Squeeze the lever 

with two hands until the rail releases the 

two tubes (Fig. 10), then push down (Fig. 

11).  NOTE:  If the top rail(s) do not release 

completely, DO NOT FORCE!  Lift the center 

of floor higher.  Both tubes must be released 

for the top rail to fold.

5. Gather four (4) corners and center all together 

tightly (Fig. 12).  Wrap Mattress around 

Playard frame with padded side facing inward. 

Secure the three (3) hook and loop straps by 

feeding them through the loops on the end 

of  the Mattress and folding them back onto 

themselves.

6. Wrap Mattress around Playard frame with 

padded side facing inward.

7. Secure the three (3) hook and loop straps by 

feeding them through the loops on the end 

of the Mattress and folding them back onto 

themselves. (Fig. 13)

8. Place folded Playard into carry bag so that the 

handle comes through the opening between 

each side of the zipper.

Fig. 4

Fig. 5

Fig. 6

Fig. 7

Rotate before 

lifting

Fig. 9

Fig. 10

Fig. 11

Fig. 12

Fig. 13

Fig. 8