Regency IG35-NG Manuale Utente

Regency IG35 Gas Inbuilt Fireplace

1)  Lay the faceplate panels fl at, face down on 

something soft so they don't scratch.

2)  Take the top faceplate and align the holes 

in it with the holes in the side panels. Us-
ing the screws provided, attach from the 
top of the panel (the holes in the top panel 
are slightly larger than the holes in the side 
panel to facilitate easier installation). 

3)  Using the connectors provided, join the left 

side trim to the top trim. Connect the right 
side trim to the top trim.

4)  Connect the fan harness to the fan switch.

5)  Connect the valve harness to the valve on/off 

switch.

6)  Tuck the wires into the faceplate to keep 

them away from the inbuilt fi replace using 
the clip provided.  Attach the clip to the rear 
of the faceplate to ensure that the wires do 
not touch the side of the unit.

7)  The power cord should be run behind the 

faceplate panel.

8)  Place the trim on the assembled faceplate 

panels and secure it with the side screws.

9)  Attach the faceplate panels* to the inbuilt 

fi replace body using 4 black screws. 

10) Push the Regency logo plate into the two 

holes in the bottom left corner of the face-
plate.

11) Place the 2 hinges for the bottom louver 

in position and secure using 4 screws per 
hinge.  

12) Place the bottom louver in position and 

secure it with 6 screws.

13) Install the safety screen by inserting the 4 

screen brackets into the 4 slots.

14) Install the top louver by sliding the 2 bracket 

clips into the brackets located on top of the 
unit.