Furuno 585 Guida Utente
4. INSTALLATION
28
4.3
Transom Mount
Transducer
Transducer
The transom mount transducer is very com-
monly employed, usually on relatively small I/
O or outboard boats. Do not use this method
on an inboard motor boat because turbulence
is created by the propeller ahead of the trans-
ducer.
DO NOT overtighten screws. They may be
damaged.
monly employed, usually on relatively small I/
O or outboard boats. Do not use this method
on an inboard motor boat because turbulence
is created by the propeller ahead of the trans-
ducer.
DO NOT overtighten screws. They may be
damaged.
525-5PWD
Choose the installation method depending on
the rise angle of the hull.
the rise angle of the hull.
525-5PWD mounting locations
Installing the 525-5PWD
A suitable mounting location is at least 50 cm
away from the engine and where the water
flow is smooth.
away from the engine and where the water
flow is smooth.
1. Drill four pilot holes for self-tapping screw
(5x20) in the mounting location.
2. Attach the transducer to the mounting loca-
tion with self-tapping screws.
3. Adjust the transducer position so the trans-
ducer faces right to the bottom.
If necessary, to improve water flow and
minimize air bubbles staying on the trans-
ducer face, incline the transducer about 5
If necessary, to improve water flow and
minimize air bubbles staying on the trans-
ducer face, incline the transducer about 5
°
at the rear. This may require a certain
amount of experimentation for fine tuning
at high cruising speeds.
amount of experimentation for fine tuning
at high cruising speeds.
4. Fill the gap between the wedge front of the
transducer and transom with epoxy mate-
rial to eliminate any air spaces.
rial to eliminate any air spaces.
Transom mount transducer, mounting flush
with hull
525-5PWD, mounting
4.4
Inside-hull Transducer
The thru-hull mount transducer (520-5PSD,
520-5MSD) may also be installed inside the
hull, following the procedure below.
520-5MSD) may also be installed inside the
hull, following the procedure below.
Necessary tools
You will need the following tools:
• Sandpaper (#100)
• Silicone sealant
• Silicone grease
• Silicone sealant
• Silicone grease
Transom
Transom
Stripe
over 10
°
Parallel with hull
Mount at the stripe.
less than 10
°
5x20
5x20
No.1 M5x14
Tape
5
°
Hull
Epoxy material
Bracket
Transducer
2 to 5
°