Garmin 90/140 Manuale Utente

I

NSTALLING

 Y

OUR

 F

ISHFINDER

 > 

I

NSTALLING

 

THE

 T

RANSDUCER

1.   Insert the rubber washer (Q) and plastic spacer (P) 

into the transducer (G) at the same time. DO NOT 

lubricate the rubber washer.

2.  Route the cable toward the back of the transducer. 

Slide the transducer into the transducer mount (H).

3.   Place a 5 mm flat washer (J) on the 10-32 x 

1.75" screw (N), and insert the screw through the 

transducer mount, spacer, and rubber washer.

4.   Place the remaining 5 mm flat washer on the 

exposed end. Install the 10-32 lock nut (L) finger 

tight. You can tighten the transducer further after 

installation on the boat.

1.   Slide the large cable tie (S) through the slot on the 

transducer mount (H) with the ridges of the band 

facing up until equal lengths extend on both sides of 

the mount. (

NOTE: For cold water, or heavy timber 

or debris areas, a metal 4-5" worm gear clamp is 

recommended.)

2.  Position the mount gasket (I) on the curved top of 

the transducer mount.

3.   Place the transducer assembly 

against the motor body of the 

trolling motor, with the front 

of the transducer pointed 

away from the trolling motor 

propeller.