Garmin TR-1 Manuale Utente

50

51

Each keypad transmitter transmits its own unique identification code when a button is pressed.  The receiver 

computer must be programmed to recognize your transmitter.  Program the receiver/transmitter pair by:

1) Turn the TR-1 Autopilot on.

2) Watch the LED on the receiver box, when it starts blinking-press any button on the wireless keypad until the 

LED stops blinking.

You will need to do this (once) anytime you change keypads.

Inside the back cover of your keypad is written a 3 Character code.  This code is the security code that your 

receiver has been trained to respond to.  If you would like to keep this code, tell the TR-1 Dealer the code 

digits when you order your new keypad.  If you do not care about the code, you will be sent a keypad with a 

randomly assigned code.  You can, of course, reprogram your receiver to recognize the new keypad when you 

take it to your boat.

When the remote control system starts to respond erratically, the keypad remote may need battery replacement.

The wireless remote keypad is powered by a CR-2032 Button Lithium Cell Battery.

To access the battery for replacement, gently pry apart the two halves 

of the keypad at the seam (fingernails will do for this)  Once the unit 

is open, remove the battery by sliding the battery out from beneath 

the retainer.  Replace with the same type of battery.

Battery