Beko CFD 540S Manuale Utente
EN
8
your appliance in a garage or an
unheated room without having to
worry about frozen food in the freezer
being spoilt. However at low ambient
temperatures mentioned above,
fridge contents are likely to freeze,
so check and consume food in the
fridge accordingly. When the ambient
temperature returns to normal, you
may change the setting to suit your
needs.
unheated room without having to
worry about frozen food in the freezer
being spoilt. However at low ambient
temperatures mentioned above,
fridge contents are likely to freeze,
so check and consume food in the
fridge accordingly. When the ambient
temperature returns to normal, you
may change the setting to suit your
needs.
3. Do not place the appliance near
cookers, radiators or in direct sunlight
as this will cause your appliance
to more electricity. If installed next
to a source of heat or freezer,
maintain the following minimum side
clearances:
as this will cause your appliance
to more electricity. If installed next
to a source of heat or freezer,
maintain the following minimum side
clearances:
From Cookers 50 mm (2”)
From Radiators 300 mm (12”)
From Freezers 25 mm (1”)
From Radiators 300 mm (12”)
From Freezers 25 mm (1”)
4. Make sure that sufficient room is
provided around the appliance to
ensure free air circulation.
ensure free air circulation.
Fit the two plastic wall spacers
supplied with the appliance onto
the condenser on the back of the
appliance by rotating 1/4 turn(See
supplied with the appliance onto
the condenser on the back of the
appliance by rotating 1/4 turn(See
Diagram).
5. The fridge/freezer should be located
on a smooth surface. The two front
feet can be adjusted as required. To
ensure that your appliance is standing
upright adjust the two front feet by
turning clockwise or anti-clockwise,
until the product is in firm contact with
the floor. Correct adjustment of feet
avoids excessive vibration and noise.
feet can be adjusted as required. To
ensure that your appliance is standing
upright adjust the two front feet by
turning clockwise or anti-clockwise,
until the product is in firm contact with
the floor. Correct adjustment of feet
avoids excessive vibration and noise.
6. Refer to cleaning and care section to
prepare your appliance for use.
A special receptacle is supplied to
store the mains plug during transit.
The receptacle is fixed at the back of
the cabinet, near to of the compressor.
(See diagram) Gently remove the plug
from the receptacle. Never pull the
mains cord, you may damage the
appliance.
from the receptacle. Never pull the
mains cord, you may damage the
appliance.
In
the
case
of
transportation, ensure you locate the
plug in the receptacle provided to avoid
transit damage.
plug in the receptacle provided to avoid
transit damage.