Lg Electronics LMX2525971 Manuale Utente

9

• To minimize noise and vibration, the refrigerator 

MUST be installed on a solidly constructed 
floor.

• To avoid vibration, the unit must be level. If 

required, adjust the leveling legs to compensate 
for unevenness of the floor. The front should be 
slightly higher than the rear to aid in door 
closing. The leveling legs can be turned easily 
by pushing against the top of the refrigerator to 
take the weight off the feet. Turn the leveling 
legs clockwise to raise the unit or 
counterclockwise to lower it.

• Carpeting and soft tile surfaces are not 

recommended.

• Never install the refrigerator on a platform or 

weakly supported structure.

NOTE: When moving the refrigerator for cleaning 
or service, be sure to protect the floor. Always 
pull the refrigerator straight out when moving it.

Do not wiggle or walk the refrigerator when trying 
to move it; floor damage could occur.

To move the refrigerator through a house door, it 
may be necessary to remove the refrigerator 
door handles.

NOTE: Handle appearance may vary from 
illustrations on this page.

w

• Use special care when removing handles to 

prevent scratching the doors.

• The handle could be damaged if you hit it with 

a hammer while removing or attaching.

• When you assemble or disassemble a handle, 

you must push or pull with reasonable force.

NOTE: It is recommend that the doors be removed when it is necessary to move the refrigerator through a

narrow opening.

Loosen the set screws with a 2.5 mm (3/32")
Allen wrench and remove the handle.

NOTE: If the handle mounting fasteners need 
to be tightened or removed, use a 1/4" Allen 
wrench.

1

Loosen the set screws located on the lower 
side of the handle with a 2.5 mm (3/32") Allen
wrench and remove the handle.

NOTE: If the handle mounting fasteners need 
to be tightened or removed, use a 1/4" Allen 
wrench.

2