Maytag MBL2258XES Manuale Utente

1. Hold a container under the dispenser while pressing the 

button.

2. Release the button to stop dispensing.

The water filter is located in the upper right-hand corner of the 
refrigerator compartment. 

The water filter status lights will remind you when it is time to 
order and replace your water filter. When the yellow (Order) light 
is on, it is almost time to change the water filter. When the red 
(Replace) light is on, a new water filter should be installed. The 
disposable water filter should be replaced at least every 6 
months OR earlier if the flow of water to your water dispenser or 
ice maker decreases noticeably.

After replacing the water filter, press and hold Reset Filter or Filter 
Reset (depending on your model) for 3 seconds. The Order and 
Replace indicator lights will blink and then go off when the 
system is reset. See “Using the Controls.” 

To purchase a replacement water filter, model UKF8001AXX-750, 
contact your dealer or call 1-877-232-6771 U.S.A. or
1-800-807-6777 Canada.

IMPORTANT: Air trapped in the water system may cause water 
and filter to eject. Always dispense water for at least 2 minutes 
before removing the filter or blue bypass cap. 

1. Turn filter counterclockwise to remove.

2. Remove sealing label from replacement filter and insert the 

filter end into the filter head.

3. Turn the filter clockwise until it stops. Snap the filter cover 

closed.

NOTE: The dispenser feature may be used without a water filter 
installed. Your water will not be filtered. If this option is chosen, 
replace the filter with the blue bypass cap.

Both the refrigerator and freezer sections defrost automatically. 
However, clean both sections about once a month to avoid 
buildup of odors. Wipe up spills immediately.

■

Because air circulates between both sections, any odors 
formed in one section will transfer to the other. You must 
thoroughly clean both sections to eliminate odors. To avoid 
odor transfer and drying out of food, wrap or cover foods 
tightly.

■

For stainless steel models, stainless steel is corrosion-
resistant and not corrosion-proof. To help avoid corrosion of 
your stainless steel, keep your surfaces clean by using the 
following cleaning instructions.

NOTE: Do not use abrasive or harsh cleaners such as window 
sprays, scouring cleansers, flammable fluids, muriatic acid,  
cleaning waxes, concentrated detergents, bleaches or cleansers 
containing petroleum products on exterior surfaces (doors and 
cabinet), plastic parts, interior and door liners or gaskets. Do not 
use paper towels, scouring pads, or other harsh cleaning tools.

1. Unplug refrigerator or disconnect power.

2. Hand wash, rinse, and dry removable parts and interior 

surfaces thoroughly. Use a clean sponge or soft cloth and a 
mild detergent in warm water. 

3. Clean the exterior surfaces.

Painted metal: Wash painted metal exteriors with a clean, 
soft cloth or sponge and a mild detergent in warm water. 
Rinse surfaces with clean, warm water and dry immediately 
to avoid water spots.

Stainless steel: Wash stainless steel surfaces with a clean, 
soft cloth or sponge and a mild detergent in warm water. 
Rinse surfaces with clean, warm water and dry immediately 
to avoid water spots. 

NOTE: When cleaning stainless steel, always wipe with the 
grain to avoid cross-grain scratching.  

4. There is no need for routine condenser cleaning in normal 

home operating environments. If the environment is 
particularly greasy or dusty, or there is significant pet traffic in 
the home, the condenser should be cleaned every 2 to 
3 months to ensure maximum efficiency.

If you need to clean the condenser:

■

Remove the base grille.

Do not use with water that is microbiologically unsafe or 
of unknown quality without adequate disinfection before 
or after the system. Systems certified for cyst reduction 
may be used on disinfected waters that may contain 
filterable cysts.