Frigidaire A01060901 Manuale Proprietario

15

The mid level and upper level lighting comes on 

automatically when the door is opened. 

To disconnect power to the unit, unplug the 

unit or switch the breaker that supplies power 

to the unit to the off position. Replace the old 

bulb with a bulb of the same wattage.

1. Turn the temperature control to OFF and 

unplug the electrical cord. 

2. Remove the lens from the lamp housing  

by unsnapping it from the lamp housing 

using your fingers or a screwdriver. Be 

careful not to break the locking tabs on the 

lamp housing. 

3. Replace the old bulb with a bulb of the same 

type and wattage. 

4. To replace the lens, snap one side of the 

lens opening to the tab on the lamp housing. 

Then carefully attach the other side. 

To Remove Light Lens

Press Tabs

in Direction Shown

Mid Level Lighting

The upper level lighting comes on automatically 

when the door is opened. 
To replace the light bulbs:

To disconnect power to the unit, unplug the 

unit or switch the breaker that supplies power 

to the unit to the off position. Replace the old 

bulb with a bulb of the same wattage.

1. To replace the light bulb, turn the 

temperature control to OFF and unplug the 

electrical cord. 

2. Remove the light shield by pushing in on the 

sides where the two tabs are located in the 

back, and then rotate the light shield down 

and out.  

puerta entreabier ta

corte de energí a

reemplace el filtro de aire

mantenga presionado 

para reinicia r

mantener  

presionado

Light Shield

Light Sheld Tabs

3. Replace the old bulb with a bulb of the same 

type and wattage. 

4. When replacing the light shield, insert the 

three tabs in the front of the light shield into 

the slots in the control box and then rotate 

the rear upward until the two retaining 

latches lock into place.