U-Line 2275ZWC Manuale Utente

2275ZWC & 2275ZWCOL

Door Alignment Check and
Adjustment

IMPORTANT

When properly aligned:

• The door will not be flush with the top of the

cabinet. The top edge of the door will be 1/8 in.
(3.175 mm) below the cabinet top.

• The door gasket will be firmly in contact with the

perimeter of the cabinet and not pinched on the
hinge side of the door.

The following procedure will correct for up to 1/4 in.
misalignment:

Figure 14. Checking Door Alignment

1. Compare the top edge of the door (opposite the

hinges) to the top edge of the cabinet (Figure 14) and
note the type (up or down) of adjustment needed.

Figure 15. Top Hinge Mounting

2. Remove the top hinge pivot pin with a Phillips

screwdriver (Figure 15) and lift door off bottom hinge
pin. Be careful not to lose the door closer insert sets.

3. Turn the door upside down and inspect the hinge plate

mounting holes.

Your plate has slotted mounting holes (Figure 16).
Loosen but do not remove the two hinge plate screws.

4. If door edge opposite the hinges needs to move up,

move plate toward outside of door. If door edge needs
to move down, move plate toward inside of door

(Figure 16). Repeat until top edge of door is parallel
with top of cabinet and tighten screws securely.

Figure 16. Door Hinge Plate Mounting Holes -

Wine Captain and Beverage Center Models

Figure 17. Bottom Hinge Door Closers

5. After adjustment is complete, remove the door closers

from the bottom hinge, clean thoroughly and apply
petroleum jelly to the mating surfaces of the closers. Be
sure that bosses on closers (Figure 17) align with holes
in the door and bottom cabinet hinge plates. Mount
door and install top hinge pivot pin.

1/8"
(3.175 mm)

ULIN_0016_A

ULIN_0133_A

Slotted Mounting Holes

Toward outside

Toward inside

ULIN_0007_A

Bosses

ULIN_0004_A