U-Line U-2175BEVCS-02 Manuale Utente

U-Line Product Operation

1

2

3

5

4

To turn the unit on or off, press and hold POWER (1) for about 
ten seconds and release. The display will show the unit set-point 
temperature when turned on and display OFF when the unit is off. 

Digital Display. 

The electronic control with digital display shows a single 
continuous set-point temperature. The factory default set-point 
for Glass Door Refrigerators and Refrigerator models is 38°F. The 
factory default set-point for Wine Captain® models is 50°F. The 
set-point temperature is a gauge for further temperature 
adjustments.

Turning the Display Off. Wine Captain® Models and Glass 
Door Refrigerators have a DISPLAY OFF mode available through 
the control panel. This allows you to control if the display will be 
ON or OFF with the door closed. The icon sequence that follows 
will switch between both modes, On or Off:

1. Press and hold WARMER (2), and simultaneously within five 

seconds press POWER (1) three times.

2. The display will be either visible or dark with the door closed.

To return to the previous mode, repeat Step 1. 

1. Press and release either WARMER (2) or COOLER (4) to put 

the controller in the SET TEMPERATURE mode. The display 
(3) will begin to flash the °F (or °C) symbol.

NOTE: This mode will self-cancel in five seconds, and the 
display (3) will show the original set-point temperature.

2. Within five seconds (while the °F (or °C) symbol is flashing), 

press WARMER or COOLER as required to adjust the set point 
temperature.

3. The change is committed five seconds after adjusting the 

temperature, and the display (3) will show the new set-point 
temperature.

Temperature °F °C Selection. U-Line products supplied for 
110 VAC have temperatures displayed (3) default in Fahrenheit 
(°F). Models supplied for 220 VAC have temperatures displayed (3) 
default in Celsius (°C).

Easily adjust the display for either type temperature display. 

Press and hold LIGHT (1) and simultaneously within five 
seconds press COOLER (5) three times to change the display 
(3) as needed.

Temperature Display. The digital display shows set-point. Under 
normal operating conditions the temperatures will fluctuate based 
on a number of factors including door openings, product load, 
room temperature, and humidity. On passive cooled units the 
temperature will always be coolest toward the bottom. 

To display actual temperature:

1. Press WARMER (2) for five seconds. The display (3) will 

indicate the actual temperature.

2. After about 10 seconds, the set point temperature will return to 

the display.

All U-Line controls are preset at the factory. Initial startup requires 
no adjustments.