U-Line CO1175 Manuale Utente

U-Line Self-Closing Door Alignment and Reversal

ULI

1. Hold door to keep it from falling.

2. Remove hinge screw pin (1) from top hinge using a Phillips 

screwdriver. 

3. Remove door by tilting forward and lifting door off bottom hinge 

closer inserts.

4. Reinstall hinge screw pin (1) into top hinge using a Phillips 

screwdriver. 

Remove plastic screw plugs (three each, top and bottom) (3) 
from new hinge location. Save for reinstallation later.

Remove existing top hinge (three screws) (2).

1. Install the hinge just removed from the top to the BOTTOM 

opposite side of the cabinet (three screws) (2).

2. Remove the two door closer inserts (4) from the existing 

bottom hinge.

3. Install door closer inserts as shown on the new bottom hinge 

(4).

Remove the existing bottom hinge (three screws) (2).

Install the hinge just removed from the bottom to the TOP 
opposite side of the cabinet (three screws) (2).

Install plastic screw plugs (three each, top and bottom) (3) into 
holes where hinge hardware was removed.

1. Remove plastic hole plug from top of door handle and reinstall 

on opposite side.

2. With bottom of door facing up, remove pivot plate (5) (two 

screws).

3. Flip over and install pivot plate on opposite side of door. Ensure 

notch in plate faces center.

1. Hold door upright and tilted forward. 

2. Lift door on to bottom hinge closer inserts.

3. Tilt door forward into position.

4. Hold door to keep it from falling.

5. Reinstall hinge screw pin (1) into top hinge using a Phillips 

screwdriver.

Align and adjust the door, see DOOR ALIGNMENT AND 
ADJUSTMENT above.