U-Line 15R Manuale Utente

02/2005

www.U-LineService.com

1. Plug in the power cord.

2. Gently push the unit into position. Be careful not to 

entangle the electrical cord. 

3. Re-check the leveling, from front to back and side to 

side. Make any necessary adjustments. The unit’s top 
surface should be approximately 1/8" below the 
countertop.

1. Locate and remove the grille screw from the cabinet, 

using a standard blade screwdriver (or a 1/4" 
nutdriver). See Figure 23.

.

2. Remove the control knob by pulling it away from the 

cabinet.

3. Identify the grille screw hole on the grille itself. It is 

located toward the top of the middle recessed section 
of the grille.

4. Place the two hook-hinges (located on the rear bottom 

side of the grille) onto the front lip of the unit base. 
Swing the grille up into position, aligning the grille 
screw hole on the grille to the grille screw hole on the 
cabinet. See Figure 24.

5. Insert the screw. Do not overtighten.

6. Reinstall control knob.

(15R Refrigerator Only)

1. Carefully remove the glass shelves from the packaging.

2. Slide the shelves onto 

lower sets of ribs, making 
sure the decorative 
graphics are on the 
underside of the shelves. 
White edge strips go 
toward the rear and silver 
edge strips go toward the 
front. See Figure 25.

Grille Screw

Hook-Hinges

Hook-Hinge

Unit Base

Front Lip

Grille