U-Line C2275DWRS Manuale Utente
U-Line Grill Overlay Installation
10
Grille Overlay
Your models grille is designed to accept a wood grille over-
lay. An overlay may be used to compliment a door overlay
and provides a seamless look for your surrounding decor.
Follow the instructions below to prepare and install your
grille overlay. Be sure to read over this chapter completely
before beginning.
lay. An overlay may be used to compliment a door overlay
and provides a seamless look for your surrounding decor.
Follow the instructions below to prepare and install your
grille overlay. Be sure to read over this chapter completely
before beginning.
Preparation
WARNING
The grille overlay MUST have venting as shown in the
drawing below. Failure to have proper venting can
result in damage to your model.
drawing below. Failure to have proper venting can
result in damage to your model.
WARNING
The grille overlay may only be installed on indoor units.
1. Prepare your overlay using the dimensions provided in the
figure on page 11. If using a hook and loop style mount, drill
hole A will not be used.
hole A will not be used.
2. If desired, stain and finish your grille to match your surrounding
decor. Follow the stain manufacturers instructions to apply stain
to your overlay.
to your overlay.
Installation
IMPORTANT
IMPORTANT
The wood overlay grille must be installed in such a
manner that the grille assembly can still be removed from
the unit.
manner that the grille assembly can still be removed from
the unit.
Screw Mount (Recommended)
1. Remove the grille from your unit by removing the two
mounting screws. See below.
2. Lay the back of your grille overlay onto the front of the grille.
Make certain the screw holes and vents are aligned.
3. Slide each of the screws removed in step 1 through the grille
overlay and grille.
4. Mount your new overlay onto your unit by screwing the overlay
back onto the base of your unit.
Hook and Loop Fastener Mount
You may also mount your overlay to your grille using hook and
loop type fasteners. U-Line recommends using 3M® Dual lock®
fasteners. To mount your overlay using a hook and loop fastener
follow the instructions below.
loop type fasteners. U-Line recommends using 3M® Dual lock®
fasteners. To mount your overlay using a hook and loop fastener
follow the instructions below.
1. Read the instructions provided with your hook and loop
fastener carefully.
2. Apply hook and loop fastener system to the back of the overlay
and front of the grille. Use the shaded areas in the diagram
below for application location.
below for application location.
3. Carefully align the wood overlay with the grille and press into
position.
9 Wood Grille Overlay
Remove Screw
Remove Screw
Back
Front
Wood Overlay
Grille
24 Inch Models
Application
Area