Smeg KSEG7 Manuale Utente

Pagina di 11
EN
6
6
WARNINGS - USE - MAINTENANCE 
4- SAFETY  USE 
  It is most important that all the warnings shown in paragraph 2 of the Installation Instructions are 
strictly observed. 
 
  Moreover, special attention must be paid to the following warnings during the use and mainte-
nance of the cooker hood: 
4.1 -  The grease filters and the charcoal filters should be cleaned or replaced as recommended by the 
manufacturer or more frequently if the hood is used consistently (more than 4 hours per day). 
4.2 - When using a gas hob in connection with the cooker hood never leave the burners of the hob 
uncovered while the hood is in use or when the pans have been removed. Switch off the gas be-
fore removing the pan or for just short periods and never leave the hob unattended. 
4.3  -  Always ensure that the appliance is kept at the correct intensity to prevent the flame from licking 
round from the bottom of the pan; this will save energy and will avoid a dangerous concentration 
of heat. 
4.4 -  Always ensure that the appliance is used in accordance with the manufacturer’s instructions for 
the removal of contaminated odours during cooking.
5 - USE 
(fig.5)
BUTTON LED 
FUNCTIONS
T1  Speed 
On 
Turns the Motor on at Speed one. 
 
Turns the Motor off. 
T2  Speed 
On 
Turns the Motor on at Speed two. 
T3  Speed 
Fixed 
When pressed briefly, turns the Motor on at Speed three. 
L 
Light 
 
Turns the Lighting System on and off. 
Warning: Button T1 turns the motor off, after first passing to speed one. 
6 - MAINTENANCE 
 
  Regular maintenance and cleaning will ensure good performance and reliability, while extend-
ing the working life of the hood. Special attentions should be paid to the grease filters and to 
the charcoal filters when the hood is used in the recirculation mode. 
6.1 -  Metal grease filters 
  1 - Cleaning 
     The metal grease filter should be cleaned every two months with normal usage and can be 
cleaned in a dishwasher or by hand using mild detergent or liquid soap. 
  2 - Replacement 
 
  The metal filters are easily removed, one at a time, applying a slight pressure towards the rear 
of the hood while pulling downwards (fig. 6).