Hoshizaki KML-200MAE Guida Utente

9

1) A HOSHIZAKI exclusive solid-state control is employed in KML-200 Series Modular

Crescent Cubers.

2) A Printed Circuit Board (hereafter called “Controller Board”) includes a stable and

high quality control system.

3) All models are pre-tested and factory-adjusted.

1. Fragile, handle very carefully.

2. A controller board contains integrated circuits, which are susceptible to

failure due to static discharge.  It is especially important to touch the
metal part of the unit when handling or replacing the board.

3. Do not touch the electronic devices on the board or the back of the

board to prevent damage to the board.

4. Do not change wiring and connections.  Especially, never misconnect

K3, K4 and K5, because the same connector is used for the Thermistor
and Float Switch.  K4 is not connected.

5. Do not fix the electronic devices or parts on the board in the field.
    Always replace the whole board assembly when it goes bad.

6. Do not short out power supply to test for voltage.

PART NUMBER

TYPE

2U0127-01

MY9KM910 (Alpine)

Note: (1) Maximum Water Supply Period - 6 minutes

Water Solenoid Valve opening, in the Defrost (Harvest) Cycle, is limited by
maximum period of the defrost timer.  The Water Valve cannot remain open
longer than the maximum period.  The Water Valve can close in less than the
maximum period if the defrost cycle is completed.