Cornelius CCM630 Manuale Utente
ED2XX 30” CCM330/430/530/630/830/1030 Nordic Style Lid Kit Installation Instructions
© 2007, IMI Cornelius Inc.
- 1 -
Publication Number: 620204731INS
INSTALLATION INSTRUCTIONS
ED2XX 30” CCM330/430/530/630/830/1030 N
ORDIC
B
LACK
/G
RAY
S
TYLE
L
ID
K
ITS
This Nordic style kit applies to the Cornelius 30” wide CCM322/522 ice maker.
CAUTION: Disconnect electrical power to the dispenser before proceeding with the icemaker
adapter kit installation.
adapter kit installation.
1.
Unpack Kit.
2.
Place insulation strip (item 12) over studs on the baffle and insert baffle assembly into the adapter
lid.
3.
Place (2) sealing washers (item 9) over studs and (2) flat washers (item 11), then fasten in place
with (2) plastic acorn nuts (item 8)
4.
Set icemaker lid on the top of the dispenser.
5.
Using the slotted holes in the lid as a template, drill four (4) .140_ diameter (9/64_) holes at the
bottom of the slots (see detail A). Use extreme care not to drill into the hopper. Fasten the lid to the
dispenser with four (4) #8 sheet metal screws, two on each side.
dispenser with four (4) #8 sheet metal screws, two on each side.
6.
Seal the icemaker to the top of the dispenser as follows:
A. Run beads of RTV around the opening in the lid and inside of the perimeter of the icemaker
outline so that the icemaker will set on the RTV.
B. Set the icemaker onto the lid and position it as required.
C. Wipe away the excess RTV.
C. Wipe away the excess RTV.
7.
Drill 9/64” diameter holes into the icemaker cabinet using the bracket as a template. Use extreme
care not to drill into any icemaker components (condenser, tubing, etc.). Secure the brackets using
the screws provided.
the screws provided.
8.
Install the wire form bracket, supplied with the bin stat kit (item 4), through the 5/8” diameter hole in
the bottom of the ice maker. Wrap the eye of the wireform over the stud near the hole to the end of
the wireform bracket and wrap the tube around the end of the bracket several times, insuring the
tube is secure.
the wireform bracket and wrap the tube around the end of the bracket several times, insuring the
tube is secure.
NOTE: The bin stat must not interfere with the agitator rotation or in the path of ice falling from
the icemaker. If it interferes with the agitator or in the path of ice, bend the bracket out of the way.
the icemaker. If it interferes with the agitator or in the path of ice, bend the bracket out of the way.
Item
No.
Part No.
Name
Qty.
1
53003
52969
52969
Cover, Gray
Cover, Black
1
2 15537
Lid
Assembly
1
3 29565
Bracket
2
4 70217
#8
Screw
6
5 50904
RTV
1
6 90221
Label
1
7 620204731INS
Installation
Instructions
1
8
620701902
Acorn Nut, 8--32 Nylon
2
9 620701901 Sealing
Washer
2
10 620037003 Baffle,
Ice
1
11
621701903
#8 Nylon Washer
2
12
620505802
Insulation Strip
1
13
630500109
Bin Stat
1
Release Date: October 5, 2007
www.cornelius.com
Revision: A