Sharp TINSKB147MRR1 Manuale Utente

Mounting

flange

1.   Place the drawer adjacent to the wall or 

cabinet opening. Plug the power supply cord  

into the electrical outlet. 

2.   Carefully guide the drawer into the prepared 

opening. Avoid pinching the cord between 

the oven and the wall. 

3.   Slide the drawer all the way until the 

mounting flange is flush with the face of the cabinet. See

Figure 8A.

4.   Open the drawer. Using the 4 holes on the drawer as a template, 

pre drill the cabinet using a 1/16" bit. See Figure 8A.

5.   Secure the drawer with the 4 screws supplied. See Figure 8B.

The name plate includes model and serial number. Open the 

Microwave Drawer fully. The label is beyond the back wall of 

the microwave cavity facing up from the flat surface.

Refer to the Operation Manual for cleaning instructions.

Read the BEFORE YOU CALL and operating instruction sections

in your Operation Manual. It may save you time and expense. 

The list includes common occurrences that are not the result of 

defective workmanship or materials in this appliance. 
Refer to the warranty in your Operation Manual for Sharp’s 

service number and address. Please call or write if you have 

inquiries about your microwave product and/or need to order 

parts.

4"

(101.6 mm)

5" (127 mm)

6"

(152.4 mm)

3 1/2"

(89 mm)

Suggested electrical

outlet location*

Anti-Tip block

The  electrical  requirements  are  a  120  volt  60  Hz,  AC  only,                

15 amp. or more protected electrical supply. It is recommended 

that a separate circuit serving only this appliance be provided.
The drawer is equipped with a 3-prong grounding plug. It must 

be plugged into a wall receptacle that is properly installed and 

grounded. Should you only have a 2-prong outlet, have a qualified

electrician install a correct wall receptacle.
Note: If you have any questions about the grounding or electrical 

instructions, consult a qualified electrician or service person.

This appliance must be grounded. The Microwave Drawer is 

equipped with a cord having a grounding wire with a grounding 

plug. It must be plugged into a wall receptacle that is properly 

installed  and  grounded  in  accordance  with  the  National        

Electrical Code and local codes 

and ordinances. In the event of 

an electrical short circuit, 

grounding reduces risk of 

electric shock by providing an 

escape wire for the electric 

current.

 – Improper use 

of the grounding plug can result 

in a risk of electric shock. Do 

3-Prong plug

Grounding pin

3-Prong receptacle

Grounded receptacle box

Grounding adapter

Grounded receptacle box

Screw

Tab for grounding screw

4 Screws

Parts supplied

SHARP ELECTRONICS OF CANADA LTD
335 Britannia Road East • Mississauga, Ontario • L4Z 1W9