ECS A785GM-M Manuale Utente

Using BIOS

Spread Spectrum (Enabled)

If you enable spread spectrum, it can significantly reduce the EMI (Electro-Magnetic
Interference) generated by the system.

HT Frequency (Auto)

CAS Latency (Tcl) (8 CLK , N/A)

Memory CLK (533 MHz, N/A)
This item is used to set the memory clock mode.

RAS/CAS Delay (Trcd) (8 CLK, N/A)

This item specifies the Row precharge to Active or Auto-Refresh of the same bank.

Row Precharge Time (Trp) (8 CLK, N/A)

This item controls the timing delay (inclockcycles) before the DRAM starts a read
command after receiving it.

This is the amount of time a CAS is performed after a RAS. The lower the better, but
some DRAM does not support low figures.

Press <Esc> to return to the M.I.B. (MB Intelligent Bios) page.

This item determins the time RAS takes to read from and write to a memory cell

Min Active RAS (Tras) (20 CLK, N/A)

Row Cycle (Trc) (27 CLK, N/A)

Use this item to specify the Row Cycle Time.

RAS/RAS Delay (Trrd) (4 CLK, N/A)

This item specifies the active-to-active delay of different banks.

Bank Interleaving (Auto)

This item is used to set the bank interleaving.

CPU/HT Reference Clock (MHz) (200)

Use this item to set the CPU/HT Reference Clock through clock gen.

When this item is enabled, BIOS will disable the clock signal of free DIMM/PCI slots.

Channel Interleaving (XOR of Address bits)
This item is used to set the channel interleaving.

DRAM Timing Mode (Auto)

This item enables you to specify the DRAM timing mode to be configured automati-
cally or manually.

Auto Detect DIMM/PCI Clk (Enabled)

When this item is enabled, BIOS will disable the clock signal of free DIMM/PCI slots.

CPU Voltage (Disabled)

This item allows users to adjust the CPU voltage

DIMM Voltage (Disabled)

This item allows users to adjust the DIMM voltage