Frigidaire 316495060 Manuale Utente

This Over the Range Microwave Oven requires a mounting 
space on a wall as shown in Figure 1. It is designed to be used 
with standard 12" wall cabinets.

Figure 1

• 

 Save these instructions for local 

inspector’s use.

• 

 Observe all governing codes and 

coordinates.

• 

 – Be sure to leave these 

instructions with the Consumer. 

• 

– Keep these instructions for 

future reference.

• 

 – Installation of this appliance requires 

basic mechanical and electrical skills.

•  Proper installation is the responsibility of the installer.

•  Product failure due to improper installation is not covered 

under the Warranty.

•  Please read all instructions thoroughly before installing 

the Over the Range Microwave Oven. Two people are 
recommended to install this product.

•  If a new electrical outlet is required, its installation should 

be completed by a qualifi ed electrician before the Over the 
Range Microwave Oven is installed. See 3 ELECTRICAL 
GROUNDING INSTRUCTIONS on page 2.

For customers in the United States and Canada
United States: 1-800-944-9044 
Canada: 1-800-265-8352

This Over the Range Microwave Oven should be mounted 
against and supported by a fl at vertical wall. The wall must be 
fl at for proper installation. If the wall is not fl at, use spacers to 
fi ll in the gaps. Wall construction should be a minimum of 2" x 
4" wood studding and 

3

/

8

" or more thick dry wall or plaster/lath. 

The mounting surfaces must be capable of supporting weight 
of 110 pounds—the oven and contents—AND the weight of 
all items which would normally be stored in the top cabinet 
above the unit.

To fi nd the location of the studs, one of the following methods 
may be used:

A.  Use a stud finder, a magnetic device which locates the 

nails in the stud.

B.  Use a hammer to tap lightly across the mounting surface 

to find a solid sound. This will indicate stud location.  

The center of the stud can be located by probing the wall with 
a small nail to fi nd the edges of the stud and then placing a 
mark halfway between the edges. The center of any adjacent 
studs will normally be 16" or 24" to either side of this mark.

ORM 1.8 [USA&Canada] [01EN].inddE1   E1

ORM 1.8 [USA&Canada] [01EN].inddE1   E1

1/22/09   10:22:41 AM

1/22/09   10:22:41 AM