Antunes, AJ 9300576 Manuale Utente

Pagina di 16
EGG STATION (ES-600 & ES-1200)
4
P/N 1010871 Rev. D 08/05
IMPORTANT SAFETY INFORMATION (continued)
In addition to the warnings and cautions in this manual, 
use the following guidelines for safe operation of the 
unit.
 
•  Read all instructions before using equipment.
 
•  For your safety, the equipment is furnished with 
a properly grounded cord connector.  Do not 
attempt to defeat the grounded connector.
 
•  Install or locate the equipment only for its intend-
ed use as described in this manual.  Do not use 
corrosive chemicals in this equipment.
 
•  Do not operate this equipment if it has a dam-
aged cord or plug, if it is not working properly, or 
if it has been damaged or dropped.
 
•  This equipment should be serviced by qualified 
personnel only.  Contact the nearest Roundup 
authorized service facility for adjustment or repair.
 
•  Do not block or cover any openings on the unit.
 
•  Do not immerse cord or plug in water.
 
•  Keep cord away from heated surfaces.
 
•  Do not allow cord to hang over edge of table or 
counter.
The following warnings and cautions appear 
throughout this manual and should be carefully 
observed.
 
•  Turn the unit off, disconnect the power source 
and allow unit to cool down before performing 
any service or maintenance on the unit.
 
•  The equipment should be grounded accord-
ing to local electrical codes to prevent the 
possibility of electrical shock.  It requires a 
grounded receptacle with separate electrical 
lines, protected by fuses or circuit breaker of 
the proper rating.
 
•  All electrical connections must be in accor-
dance with local electrical codes and any 
other applicable codes.
 
•  WARNING ELECTRICAL SHOCK HAZARD.  
FAILURE TO FOLLOW THESE INSTRUCTIONS 
COULD RESULT IN SERIOUS INJURY OR 
DEATH.
-  Electrical ground is required on this appli-
ance.
-  Do not modify the power supply cord plug.  
If it does not fit the outlet, have a proper 
outlet installed by a qualified electrician.
-  Do not use an extension cord with this 
appliance.
-  Check with a qualified electrician if you 
are in doubt as to whether the appliance is 
properly grounded.
 
•  If the supply cord is damaged, it must be 
replaced by the manufacturer or its service 
agent.
 
•  Do not clean this appliance with a water jet.
 
•  Do not use a sanitizing solution or abrasive 
materials. The use of these may cause dam-
age to the stainless steel finish.
 
•  Chlorides or phosphates in cleansing agents 
(e.g. bleach, sanitizers, degreasers or deter-
gents) could cause permanent damage to 
stainless steel equipment.  The damage is 
usually in the form of discoloration, dulling 
of metal surface finish, pits, voids, holes or 
cracks.  This damage is permanent and not 
covered by warranty.