Smeg PL115X Manuale Utente
User instructions
13
In case that the door is opened during the operation, to the next door
closing it is going to be necessary to start the program as shown in
paragraph “
closing it is going to be necessary to start the program as shown in
paragraph “
S
TARTING THE PROGRAM
”. The program will resume from the
point in which it was interrupted.
In case that the tub temperature is higher than 50°C the program
will start about 30 seconds later.
In case that the tub temperature is higher than 50°C the program
will start about 30 seconds later.
HALF LOAD WASH SETTING (certain models only)
(available in all programs except the soak program)
(available in all programs except the soak program)
This function is ideal for small loads and saves water and electricity. It is
controlled by the HALF LOAD button (5) and allows washing in the
upper basket only.
controlled by the HALF LOAD button (5) and allows washing in the
upper basket only.
IMPORTANT: at the end of the program remember to deactivate the
function to ensure the next wash is not also carried out in half load
mode by mistake.
function to ensure the next wash is not also carried out in half load
mode by mistake.
A cutlery basket can be placed in the upper basket, while the lower
basket must be left empty.
basket must be left empty.
CAUTION: there is no point in loading dishes and cutlery in the
lower basket, since the jet of water will only reach the upper basket.
lower basket, since the jet of water will only reach the upper basket.
DELAYING THE PROGRAM
(presente solamente su alcuni modelli)
(disponibile in tutti i programmi escluso l'ammollo)
(presente solamente su alcuni modelli)
(disponibile in tutti i programmi escluso l'ammollo)
The PROGRAM DELAY button (7) can be pressed to delay the start of
the washing program by 3,6 or 9 hours. This function allows you to set
the dishwasher to work at your preferred time of day.
After selecting the delay, start the program (see relative section).
The appliance will prewash the dishes, after which the “program delay”
set previously will come into effect (light 8 indicating the time left before
the start of the program and light 4 indicating the program set flash).
the washing program by 3,6 or 9 hours. This function allows you to set
the dishwasher to work at your preferred time of day.
After selecting the delay, start the program (see relative section).
The appliance will prewash the dishes, after which the “program delay”
set previously will come into effect (light 8 indicating the time left before
the start of the program and light 4 indicating the program set flash).