Eureka fdem 3101 Manuale Utente

1. Remove the appliance from all packaging and check
that it has not been damaged during transportation.
If it has been damaged, contact the retailer and do not
proceed any further with the installation process.

2. Check the dishwasher by placing it so that its sides or
back panel are in contact with the adjacent cabinets or
even with the wall. This appliance can also be recessed
under a single worktop

*

  (

see the Assembly instruction

sheet

).

3. Position the dishwasher on a level and sturdy floor. If the
floor is uneven, the front feet of the appliance may be adjusted
until it reaches a horizontal position (the angle of inclination
must not exceed 2 degrees). If the appliance is levelled
correctly, it will be more stable and much less likely to move
or cause vibrations and noise while it is operating.

4

*

. Adjust the height of the rear foot from the front of the

appliance* on the central lower part of the dishwasher,
turning a hexagonal spanner (red color) with an opening
of 8 mm in a clockwise direction to increase the height or
in an anticlockwise direction to decrease the height.

After installing the dishwasher, open the door and stick the
adhesive transparent strip under the wooden shelf in order
to protect it from any condensation that may form.

 Keep this instruction manual in a safe place for future

reference. If the appliance is sold, given away or moved,
please ensure the manual is kept with the machine, so that
the new owner may benefit from the advice contained within
it.

 Please read this instruction manual carefully: it contains

important information regarding the safe installation, use
and maintenance of the appliance.

 If the appliance must be moved at any time, keep it in

an upright position; if absolutely necessary, it may be tilted
onto its back.

This appliance is intended to be used in household

and similar applications such as:
- staff kitchen areas in shops, offices and other working
environments;
- farm houses;
- by clients in hotels, motels and other residential type
environments;
- bed and breakfast type environments.

After the appliance has been installed, immediately before
running the first wash cycle, completely fill the salt
dispenser with water and add only then approximately 1 kg
of salt (

see chapter entitled Rinse aid and refined salt

). The

water may overflow: this is normal and is not a cause for
concern. Select the water hardness value (

see chapter

entitled Rinse aid and refined salt

).  - After the salt has

been poured into the machine, the LOW SALT indicator
light

*

 switches off.

 If the salt container is not filled, the water softener and

the heating element may be damaged as a result.

*

 Only available in selected models.

width 60 cm 
height 85 cm 
depth 60 cm 

14 standard place-settings 

0,05 ÷ 1MPa (0.5 ÷ 10 bar) 
7,25 – 145 psi 

See appliance data plate 

See appliance data plate 

See appliance data plate 

 

This dishwasher conforms to the 
following European Community 
Directives:  
-2006/95/EC  (Low Voltage) 
-2004/108/EC (Electromagnetic 
Compatibility)  
-2005/32/EC (Comm. Reg. 
1275/2008) (Ecodesign) 
-97/17/EC (Labelling) 
-2002/96/EC Waste Electrical  
and Electronic Equipment 
(WEEE)