Chauvet Vue II Manuale Utente

Often, the setup for Master-Slave 
and Standalone operation requires 

at the first fixture in the chain be 
itialized for this purpose via either 

ttings in the control panel or DIP-

th
in
se
switches. Secondarily, the fixtures 
that follow may also require a slave 
setting. Please consult the 
“Operating Instructions” section in 
this manual for complete instructions 
for this type of setup and 
configuration. 

Note! 
Clamp is sold separately.

 

1.  Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector 

of the first fixture.   

fixture which will have a (female) 3 pin 

consisting of a (male) 3 pin connector. Then, 

 

 

 

This fixture may be mounted in any position provided there is adequate room for ventilation. 

fixture by loosening both knobs and tilting the fixture. After finding the 

desired position, retighten both knobs. 

• 

• 
• 

Never mount in places where the fixture will be exposed to rain, high 

 

2.  Connect the end of the cable coming from the first 

connector to the input connector of the next fixture 

proceed to connect from the output as stated above to the input of the following fixture and so on. 

 

It is important never to obstruct the fan or vents pathway. Mount the 

fixture using, a suitable “C” or “O” type clamp. Adjust the angle of the 

When selecting installation location, take into consideration lamp 

replacement access and routine maintenance.  

Safety cables should always be used.  

humidity, extreme temperature changes or restricted ventilation. 

Vue™ II User Manual 

9 

2007-05-10/13:15