Chicago Electric 68886 Manuale Utente

Pagina di 32
Page 14
For technical questions, please call 1-800-444-3353.
SKU 68886 
        
17. To check the wire’s drive tension, feed the wire 
against a piece of wood from 2 to 3 inches away.   
If the wire stops instead of bending, 
turn the welder OFF, unplug it, 
slightly tighten the feed tensioner clockwise, 
and try again.   
If the wire bends from the feed pressure, 
then the tension is set properly.
18. 
TURN THE WELDER OFF.
19. Select a Contact Tip that is compatible with the 
welding wire used.  The pre-installed Tip is .035″.  
Slide the Contact Tip over the wire 
and thread it clockwise into the Torch.  
Tighten the Contact Tip using the Multi-wrench.
20. Replace the Nozzle and cut the wire 
off at 
1
/
2
″ from tip (
1
/
2
″ stickout).
21. Swing the Door closed, lift the door latch, press 
on the bottom center of the Door until the door 
is completely closed, and release the latch.
MIG 180
WIRE FEED WELDER
ITEM 68886
WIRE FEED SPEED
240V~
 
I
O
Torch
Nozzle
Contact
Tip
door 
latch
Door
2-3″
Incrementally  
increase tension  
until  
wire bends.
SAFETY
MAINTENANCE
BASIC WELDING
WELDING TIPS
SETUP