Honeywell DR4300 Manuale Utente

The DR4300 is available as a limit controller. Most set up groups described in Subsections 4.3.7 through 
4.3.20 apply to limit control, and are configured for the limit controller the same way they are for other 
recorders.  
The exceptions are: 

•  Control set up group contains special parameters for limit control in place of those described in 

Subsection 4.3.11. The limit control set up parameters that replace those in Subsection 4.3.11 are 
listed in Table 4-19. 

•  Alarm 1 is not available.  

 

HI         [factory setting] 
LO 

— Limit action occurs when PV exceeds SP. 

 — Limit action occurs when PV is less than SP. 

 

NORM 

RST         [factory setting] 

— Normal limit control on power up. 

— Powers up in limit state. Recorder will not begin 

normal limit control until RESET key is pressed.* 

–999 to 9999 
 
  [factory setting = 100] 

—This parameter 

prevents the local setpoint from going above the value 
specified here. The setting must be equal to or less than 
the upper range of the input. 

–999 to 9999 
 
  [factory setting = 0] 

—This parameter 

prevents the local setpoint from going below the value 
specified here. The setting must be equal to or greater 
than the lower range of the input. 

 
 
 
 

DIS [factory setting] 
 
 

ENAB 

—Use this parameter to enable or 

disable resetting the limit controller (taking it out of the 
limit state) using Remote Switch 1 (digital  
input 1). 

— When external reset is disabled, the limit controller 

can be reset only by pressing the MAN/AUTO/RESET 
key on the recorder. 

— When external reset is enabled, the limit 

controller can be reset two ways: by pressing the 
MAN/AUTO/RESET key on the recorder, or by turning on 
digital input 1 (contact closed).