Grizzly G8122 Dépliant
Specifications
No-Load Speed ............................... 18,000 RPM
Wheel Size ............................. 3" Dia. x
Wheel Size ............................. 3" Dia. x
3
⁄
8
" Arbor
Air Inlet ....................................................
1
⁄
4
" NPT
Average Air Consumption .......................... 4 cfm
Weight .........................................................2 lbs.
Weight .........................................................2 lbs.
Operation
Connect to air and press the trigger to operate. To
reduce the risk of injury, always keep the safety
guard installed for all operations.
reduce the risk of injury, always keep the safety
guard installed for all operations.
Replacing Wheels
Use the included wrenches to replace the cut-off
wheels. Do not use cracked wheels or they might
fly apart during operation. Only use wheels rated
for 18,000 rpm or higher. Make sure wheels are
installed so the rotation direction on the wheel and
saw match. Make sure the washer is reinstalled
between the cut-off wheel and the cap screw.
wheels. Do not use cracked wheels or they might
fly apart during operation. Only use wheels rated
for 18,000 rpm or higher. Make sure wheels are
installed so the rotation direction on the wheel and
saw match. Make sure the washer is reinstalled
between the cut-off wheel and the cap screw.
Lubrication
To improve tool lifespan, use a filter/lubricator/
regulator setup as shown in
regulator setup as shown in
Figure 2. Otherwise,
lubricate multiple times daily with 2–3 drops of
pneumatic tool oil. Place the oil directly into the air
fitting as shown in
pneumatic tool oil. Place the oil directly into the air
fitting as shown in
Figure 3.
Figure 1.
Model G8122.
Figure 3.
Lubricating directly into air fitting.
If you need help with your new pneumatic tool,
call our Tech Support at: (570) 546-9663.
call our Tech Support at: (570) 546-9663.
EYE INJURY HAZARD!
Always wear safety glasses
or a face shield during use
to prevent injury.
INJURY HAZARD!
When servicing, always dis-
connect tool from air to pre-
vent unexpected operation.
90 PSI
MAX AIR PRESSURE!
Exceeding this PSI may
result in injury/tool damage.
Quick
Connector
Connector
Quick
Coupler
Coupler
Air Hose
Quick
Coupler
Coupler
Quick
Connector
Connector
Lubricator
Filter
Regulator
Air
Compressor
Your
Tool
Figure 2.
Installing a filter/lubricator/regulator to
improve the lifespan of your tool.
MODEL G8122
AIR CUT-OFF SAW
INSTRUCTIONS