Hitachi Koki USA CW 20 Manuale Utente

–  11  – 

1.   Unpack all parts and group by type and size. Refer      

to the parts list for correct quantities.

2.    Attach one short upper support (1) to top of leg (2)      

using one bolt (3) and nut (4).

      

NOTE: 

●    Align detents in stand leg with support brackets 

to ensure proper fit. 

●    Do not tighten bolts until stand is properly 

aligned (see step #8 before tightening).

3.    Attach other end of short upper support to top of      

another leg using one bolt and nut.

4.    Attach one short bottom support (5) to center of 

each leg using bolt (3) and nut (4). This completes 

the front frame section.

5.    Assemble rear frame section in exactly the same      

manner.

6.   Join front and rear frame assemblies using two long     

upper supports (6) and two long bottom supports      

(7), bolts and nuts.

7.   Insert foot pad (8) into bottom of leg. Repeat for       

each leg.

8.    Place stand on level surface and adjust so all legs       

are contacting the floor and are at similar angles to       

the floor, and detents in stand leg align with support 

brackets, then tighten all bolts.

      

NOTE: To avoid rocking, tighten all bolts.

9

10

12

1

5

2

7

6

4

8

3

●    The stand is designed only for using with scroll      

●    Do not climb, sit or stand on the stand assembly.

●    Do not use the stand on uneven or unstable 

1.   To mount your scroll saw to the stand, position the 

leg stand (1) on a firm, level surface.

2.   Matching the holes (2) in the scroll saw base with 

the holes in the leg stand, place the scroll saw on 

the stand.

3.   Secure the stand and saw using the hex head bolts 

(9), flat washers (10), sleeve (11) and nuts (12) 

provieded. 

4.   Tighten all four nuts. 

      

NOTE: Do not over tighten nuts holding saw to 

stand. This may damage this saw base. 

9

10

12

1

2

11