Grizzly H0594 Manuale Utente
Introduction
This 8,000 RPM air sander requires 90 PSI and
6 CFM. Air inlet is
6 CFM. Air inlet is
1
/
4
" NPT. Requires 3
1
/
2
" x 8
1
/
2
"
sanding sheets. (You can cut a standard 9" x 11"
sanding sheet into thirds and trim each piece to
size.)
sanding sheet into thirds and trim each piece to
size.)
Inventory
A. Pneumatic Jitterbug Sander ....................... 1
MODEL H0594
PNEUMATIC JITTERBUG
SANDER
INSTRUCTION SHEET
Figure 2. Attaching sanding sheet.
Figure 1
.
Model H0594.
Assembly and Attaching Abrasives
To assemble the sander and attach the sand-
paper:
1. Install a
1
⁄
4
" NPT male quick-disconnect fitting
(not included) into the air inlet.
2. Press one clamp open, insert one end of the
sandpaper between the clamp and the base
as shown in
as shown in
Figure 2 and release pressure
on the clamp to secure the paper.
3. Fold the sandpaper over the sander, and
secure the paper in the opposite clamp, mak-
ing sure the paper fits snugly as shown in
ing sure the paper fits snugly as shown in
Figure 3.
Figure 3. Attaching sandpaper on opposite side.
COPYRIGHT © MAY, 2006 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#BL8253 PRINTED IN TAIWAN
EYE INJURY HAZARD!
Always wear safety glasses
when using this tool to
prevent serious personal
injury.
INJURY HAZARD!
Always disconnect tool from
air to prevent unexpected
operation during service.
DUST HAZARD!
Always wear respirator when
using this tool.