Nikon 9000ED Manuale Utente

If the dialog shown at right appears the fi rst time the scanner is 
connected and turned on, the IEEE 1394 driver update has not been 
completed.  Update the IEEE 1394 drivers as described in “Updat-
ing the IEEE 1394 Drivers (Windows 98 SE Only): The ‘Insert Disk’ 
Dialog”

 (

 65).

A “Digital Signature Not Found” dialog will be displayed the fi rst 
time the scanner is connected and turned on following installation 
of Nikon Scan.  Click Yes to register the scanner with Windows.

Before turning on the scanner for the fi rst time, make sure that Nikon Scan is installed on the 
computer and that the power and IEEE 1394 cables are connected.  For information on install-
ing Nikon Scan and connecting the cables, see “Setup” (

 7).

1 

Turn the computer on
Turn the computer on and wait for the operating system to start up.

2 

Turn the scanner on
The status LED will blink for about two minutes while the scanner initializes.  The status 
LED will stop blinking when initialization is complete.

Scanner off

Status LED off

Scanner on

Status LED blinks

Status LED on

If the status LED fl ashes quickly (about fi ve times a second), turn the scanner off, wait at least fi ve sec-
onds, and turn the scanner on again.  If the problem persists, see “Troubleshooting” (

 63).