Allied Telesis AT-S87 Manuale Utente
AT-S87 Version 1.0.0 Software Release Notes
PN 613-000911 Rev B
3
Allied Telesis, Inc.
A 1000 MB SFP module can be auto detected when you insert it into the AT-GS950/48
Gigabit Ethernet Smart Switch. However, you must configure the port mode to Auto for the
Gigabit SFP module to become operational per the procedure given above.
Gigabit Ethernet Smart Switch. However, you must configure the port mode to Auto for the
Gigabit SFP module to become operational per the procedure given above.
A 1000 MB SFP module can be manually configured for 1000 full duplex with no auto-
negotiation by setting the SFP port Mode to “1G-Full” per the procedure given above.
negotiation by setting the SFP port Mode to “1G-Full” per the procedure given above.
To activate a port configuration change, be sure to perform the following steps after selecting
and changing a configuration parameter for either a copper or SFP port on the Physical
Interface page:
and changing a configuration parameter for either a copper or SFP port on the Physical
Interface page:
1. Click the Modify button on the Physical Interface page.
2. Click the OK button on the Physical Interface page.
3. To activate these changes and permanently save these settings to the configuration file,
2. Click the OK button on the Physical Interface page.
3. To activate these changes and permanently save these settings to the configuration file,
go to the Save Configuration page and click on the Save button. The port configuration
changes will only take affect after completing this step.
changes will only take affect after completing this step.