Motorola T1/E1 Manuale Utente
![Motorola](https://files.manualsbrain.com/attachments/83de88ba2280e7232128e8931d7cbd2a38dcc654/common/fit/150/50/0293f422c4d32e7e0f777d5e11bc33c83ea5627f71ddf155374c02a23d9a/brand_logo.png)
Canopy T1/E1 Multiplexer
September 2004
T1/E1 Multiplexer FPGA Version 3.4
Page 58 of 73
3.4.1 Invoking a T1/E1 Loopback using the CLI
Follow the steps below to invoke a T1/E1 Loopback from the CLI.
Procedure 27: Invoking a T1/E1 loopback using the CLI
Action Steps
Log in
Press Enter.
At the username prompt, enter admin.
At the password prompt, enter password.
Set T1/E1 into Loopback
Mode
Mode
Enter set line loopback [1/2/3/4] [on/off]
where
[1/2/3/4]
represents T1/E1 ports 1 through 4.
on
will enable T1/E1 loopback.
off
will remove the T1/E1 loopback.
The system responds
Line [1/2/3/4] loopback is: [on/off]
Log off
Enter lo.
RESULT: The system responds goodbye.
RESULT: The system responds goodbye.
end of procedure
3.4.2 Invoking a T1/E1 Loopback Using the EMS
Procedure 28: Invoking a T1/E1 loopback using the EMS
Use this procedure to invoke a T1/E1 Loopback from the EMS.
1. Select
the
Test
→Loopback menu option.
RESULT: The Loopback Test dialogue box opens.
2. Select the target T1/E1 Channel by clicking on the appropriate tab.
3. Use
the
On or Off radio button to invoke or remove the T1/E1 loopback.
RESULT: The Loopback is immediately invoked or removed.
end of procedure
Issue 3