Extreme networks Summit1 Manuale Utente

S

UMMIT

 S

WITCH

 I

NSTALLATION

 

AND

 U

SER

 G

UIDE

7-5

C

ONFIGURING

 STP 

ON

 

THE

 S

UMMIT

C

ONFIGURING

 STP 

ON

 

THE

 S

UMMIT

STP configuration involves the following actions:

Create one or more STP domains using the following command:

create stpd <stpd_name>

STPD, VLAN, and QoS profile names must all be unique. For example, a name 
used to identify a VLAN cannot be used when you create an STPD or a QoS 
profile.

Add one or more VLANs to the STPD using the following command:

config stpd <stpd_name> add vlan <name>

Enable STP for one or more STP domains using the following command:

enable stpd [<stpd_name> | all]

All VLANs belong to a STPD. If you do not want to run STP on a VLAN, you 
must ad the VLAN to a STPD that is disabled.

Once you have created the STPD, you can optionally configure STP parameters for the 
STPD.

You should not configure any STP parameters unless you have considerable 
knowledge and experience with STP. The default STP parameters are adequate 
for most networks.

The following parameters can be configured on each STPD:

Hello time

Forward delay

Max age

Bridge priority

The following parameters can be configured on each port:

Path cost

Port priority

The device supports the RFC 1493 Bridge MIB. Parameters of only the s0 default 
STPD are accessible through this MIB.

Summit.bk : 7STP.FM  Page 5  Thursday, June 18, 1998  9:27 AM