3com 4500 PWR 26-PORT Manuale Utente
SNMP Configuration Commands
389
[SW4500]snmp-agent target-host trap address udp-domain 2.2.2.2
params securityname comaccess
[SW4500]
To enable Trap messages to be sent to
2.2.2.2
with a community name of
public
, enter the following:
<SW4500>system-view
System View: return to User View with Ctrl+Z.
[SW4500]snmp-agent trap enable
[SW4500]snmp-agent target-host trap address udp-domain 2.2.2.2
params securityname public
[SW4500]
snmp-agent trap enable
Syntax
snmp-agent trap enable [ configuration | flash | ospf [ process-id ]
[ ospf-trap-list ] | standard [ authentication | coldstart | linkdown
| linkup | warmstart ]* | system ]
undo snmp-agent trap enable [ bgp [ backwardtransition ] [
established ] | configuration | flash | ospf [ process-id ] [
ospf-trap-list ] | standard [ authentication | coldstart | linkdown |
linkup | warmstart ]* | system ]
View
System view
Parameter
configuration:
Configure to send SNMP configuration Trap packets.
flash:
Configure to send SNMP flash Trap packets.
ospf [ process-id ] [ ospf-trap-list ]
: Configure to send the OSPF trap
packets.
process-id
is the ID of the OSPF process, ranging from 1 to 65535.
ospf-trap-list
is the list of OSPF trap information.
standard [ authentication | coldstart | linkdown | linkup | warmstart
]*
: Configure to send standard Trap messages.
authentication
: Configure to send SNMP authentication Trap messages
when authentication fails.
coldstart
: Configure to send SNMP cold start Trap messages when switch is
rebooted.
linkdown
: Configure to send SNMP link down Trap messages when switch port
turns down.
linkup
: Configure to send SNMP link up Trap messages when switch port
turns up.
warmstart
: Configure to send SNMP warm start Trap messages when snmp is
re-enabled.
system:
Configure to send SysMib trap messages.