Q-Logic 5802V Manuale Utente
7 – Zoning Configuration
Saving the Active and Merged Zone Sets
59263-01 A
7-13
A
Saving the Active and Merged Zone Sets
You can save the active zone set and merged zone set to the non-volatile zoning
database. Enter the
database. Enter the
Capture to save the active zone set as shown
in the following example:
SANbox (admin) #> zoning active capture
This command will overwrite the configured zoning database in NVRAM.
Please confirm (y/n): [n] y
The active zoning database has been saved.
Enter the
Capture to the save the merged zone set as shown in
the following example:
SANbox (admin) #> zoning merged capture
This command will overwrite the configured zoning database in NVRAM.
Please confirm (y/n): [n] y
The merged zoning database has been saved.
Resetting the Zoning Database
There are two ways to remove all aliases, zones, and zone sets from the zoning
database:
database:
Enter the
command as shown in the following example:
SANbox #> admin start
SANbox (admin) #> zoning edit
SANbox (admin-zoning) #> zoning clear
SANbox (admin-zoning) #> zoning save
Enter the
Zoning command as shown in the following example. The
zoning configuration values, MergeAutoSave, DefaultZone, and
DiscardInactive remain unchanged. This is the preferred method.
DiscardInactive remain unchanged. This is the preferred method.
SANbox #> admin start
SANbox (admin) #> reset zoning