Q-Logic 5802V Manuale Utente

13 – Simple Network Management Protocol Configuration

Modifying the SNMP Configuration

13-4

59263-01  A

S

Enter the 

 command in an Admin session to configure SNMP on 

the switch. There are two groups of configuration parameters. One group is 
common to all traps. The second group is trap specific. You can configure both 
groups of parameters for all SNMP traps, or you can configure the common and 
trap-specific parameters separately. Refer to 

 for descriptions of the 

common and trap-specific SNMP parameters.

The following example configures the common SNMP trap configuration 
parameters:

SANbox (admin) #> set setup snmp common

A list of attributes with formatting and current values will follow.

  Enter a new value or simply press the ENTER key to accept the current value.

  If you wish to terminate this process before reaching the end of the list

  press 'q' or 'Q' and the ENTER key to do so.

  Current Values:

    SnmpEnabled      True

    Contact          <sysContact undefined>

    Location         <sysLocation undefined>

    ReadCommunity    public

    WriteCommunity   private

    AuthFailureTrap  False

    ProxyEnabled     True

    SNMPv3Enabled    False

  New Value (press ENTER to not specify value, 'q' to quit):

    SnmpEnabled      (True / False)         :

    Contact          (string, max=64 chars) :

    Location         (string, max=64 chars) :

    ReadCommunity    (string, max=32 chars) :

    WriteCommunity   (string, max=32 chars) :

    AuthFailureTrap  (True / False)         :

    ProxyEnabled     (True / False)         :

    SNMPv3Enabled    (True / False)         :

  Do you want to save and activate this snmp setup? (y/n): [n]