Q-Logic 5802V Manuale Utente

14 – Command Reference

Set Config Port

14-86

59263-01  A

S

Sets the port configuration parameters for one or more ports. The changes you 
make with this command are not retained when you reset or power cycle the 
switch unless you save them using the Config Save command.

Admin session and a Config Edit session

or

Initiates an edit session in which to change configuration parameters for the port 
number given by [port_number]. If you omit [port_number], the system begins with 
port 0 and proceeds in order through the last port. For each parameter, enter a 
new value or press the Enter key to accept the current value shown in brackets. 
Enter “q” to end the configuration for one port, or “qq” to end the configuration for 
all ports. 

 describes the port configuration parameters.

Initiates an editing session in which to change configuration parameters for all 
ports based on the configuration for the port given by [port_number]. If you omit 
[port_number], port 0 is used. For each parameter, enter a new value or press the 
Enter key to accept the current value shown in brackets. Enter “q” to end the 
configuration. 

 describes the port configuration parameters.

AdminState

Port administrative state:

„ Online – Activates and prepares the port to send data. 

This is the default.

„ Offline – Prevents the port from receiving signal and 

accepting a device login.

„ Diagnostics – Prepares the port for testing and prevents 

the port from accepting a device login.

„ Down – Disables the port by removing power from the 

port lasers.