Q-Logic 5802V Manuale Utente
14 – Command Reference
Set Config Zoning
59263-01 A
14-99
A
Set Config Zoning
Configures the zoning database. The changes you make with this command are
not retained when you reset or power cycle the switch unless you save them using
the
not retained when you reset or power cycle the switch unless you save them using
the
Save command.
Authority
Admin session and a Config Edit session
Syntax
set config zoning
Initiates an editing session in which to change the zoning database configuration.
The system displays each parameter one line at a time and prompts you for a
value. For each parameter, enter a new value or press the Enter key to accept the
current value shown in brackets.
The system displays each parameter one line at a time and prompts you for a
value. For each parameter, enter a new value or press the Enter key to accept the
current value shown in brackets.
Table 14-24. Zoning Configuration Parameters
Parameter
Description
MergeAutoSave
Enables (True) or disables (False) the saving of changes to active
zone set in the switch’s non-volatile zoning database.The default
is True.
zone set in the switch’s non-volatile zoning database.The default
is True.
Disabling the MergeAutoSave parameter can be useful for pre-
venting the propagation of zoning information when experiment-
ing with different zoning schemes. However, leaving the
MergeAutoSave parameter disabled can disrupt device configura-
tions should a switch have to be reset. For this reason, the Mer-
geAutoSave parameter should be enabled in a production
environment.
venting the propagation of zoning information when experiment-
ing with different zoning schemes. However, leaving the
MergeAutoSave parameter disabled can disrupt device configura-
tions should a switch have to be reset. For this reason, the Mer-
geAutoSave parameter should be enabled in a production
environment.
DefaultZone
Enables (Allow) or disables (Deny) communication among
ports/devices that are not defined in the active zone set or when
there is no active zone set. The DefaultZone value must be the
same on all switches in the fabric. The default is Allow.
ports/devices that are not defined in the active zone set or when
there is no active zone set. The DefaultZone value must be the
same on all switches in the fabric. The default is Allow.
DiscardInactive
Enables (True) or disables (False) the discarding of all inactive
zone sets from that zoning database. Inactive zone sets are all
zone sets except the active zone set. The default is False.
zone sets from that zoning database. Inactive zone sets are all
zone sets except the active zone set. The default is False.