Q-Logic 5802V Manuale Utente

14 – Command Reference

Show Alarm

59263-01  A

14-135

A

Displays the alarm log and session output stream display setting.

None

Displays the status of the parameter that controls the display of alarms in the 
session output stream. This parameter is set using the 

 command.

The alarm log is cleared when the switch is reset or power cycled.

The following is an example of the Show Alarm command:

SANbox #> show alarm

[1][Fri Jan 19 13:50:26.508 UTC 2007][A][1004.000F][Port: 4][Eport Isolating 

due to Merge Zone Failure]

  [2][Fri Jan 19 13:50:26.513 UTC 2007][A][1004.0030][Topology change, lost 

route to switch with domain ID 1]

  [3][Sun Jan 21 07:59:28.677 UTC 2007][A][1004.0030][Topology change, lost 

route to switch with domain ID 99]

  [4][Sun Jan 21 07:59:29.367 UTC 2007][A][1004.0030][Topology change, lost 

route to switch with domain ID 101]

The following is an example of the Show Alarm Settings command:

SANbox #> show alarm settings

  Current settings for alarm

  --------------------------

  display  ON