Blomberg TKF 7230 Manuale Utente

Pagina di 44
20 - EN
7
   Solution suggestions for problems
Problem
Cause
Explanation / Suggestion
Drying process 
takes too much 
time. 
 Cover filter and filter drawer 
might have not been cleaned.
* Clean the cover filter and Filter drawer.
Laundry come 
out wet at the 
end of drying.
* Cover filter and filter drawer 
might have not been cleaned.
* Excessive laundry might have 
been loaded in.
* Clean the cover filter and Filter drawer.
* Do not overload the machine.
Machine does
not switch on 
or the program 
does not start. 
Machine is not
activated when 
set.
* It might have not been 
plugged in.
* The loading door may be ajar.
* Program might have not been
set or the "Start/Pause/Cancel"
button might have not been 
pressed.
* "Childproof lock" might have 
been activated.
* Make sure that the machine is plugged in.
* Make sure that the loading door is properly
closed.
* Make sure that the program has been set and it
is not in “Stop” mode.
* Deactivate the childproof lock.
Program has
been interrupted 
without any 
cause.
* The loading door may be ajar.
* Electricity may be cut off.
* Make sure that the loading door is properly
closed.
* Press the "Start/Pause/Cancel" button to start
the program.
Laundry has 
shrunk, become 
felted or 
deteriorated.
* A program suitable for the 
laundry type might have not 
been used.
* Dry only the laundry which is suitable for drying 
in your machine after checking the labels on your 
clothes.
* Select a program with suitable temperature for 
the laundry type to dry your clothes.
Drum lightning 
does not come 
on.
(for models 
equipped with a 
lamp)
* The machine might have not 
been started by using the On/
Off button.
* Bulb may have blown.
* Make sure that the machine is On.
* Call the authorized service to replace the bulb.
“Final / Anti-
creasing” light 
flashes.
* The 2-hour anti creasing 
program to prevent laundry 
from creasing might have been 
activated.
* Turn off the machine and take out the laundry.
“Final / Anti-
creasing” light 
is on.
* Program has come to an end. * Turn off the machine and take out the laundry.
The “Drying” light
flashes.
* A heat sensor failure has 
occurred. Machine ends the
program without heating.
* Turn off the machine and take out the laundry. 
Call your authorized service.
Also, for products equipped with a “Condenser” and a “Heat pump”
“Tank full”
warning light is 
on.
* Water may be full.
* Anti-creasing program might 
be running.
* Drain the water in the water tank.
“Filter cleaning”
light is on.
* Filter might have not been 
cleaned.
* Clean the cover filter.
“Condenser
cleaning” light 
is on.
* Filter drawer/Condenser might 
have not been cleaned.
* Clean the filters in the condenser/filter drawer 
under the kick plate.
A
 Call an authorized service if the problem persists.