HP (Hewlett-Packard) 24A Manuale Utente

The connections between the analyzer and the HP 8360 series are
similar to the connections between the analyzer and the
HP 

 The HP 8360 series differs from the HP 

 in

one connection only. It unnecessary to connect the modulator drive
signal from the analyzer to the source. The HP 8360 series internally
produces the 27.8 

 modulated signal necessary for AC mode

measurements on the analyzer. The connections from the HP 8360
series to the analyzer are:

n 

Z-AXIS 

n 

SWEEP OUTPUT

n 

STOP SWEEP IN/OUT

n 

HP-IB Interface

Configure the general-purpose HP 8360 series to HP-IB address 19
and network analyzer language for operation with the analyzer. For

information on selecting the instrument address and language refer to
earlier paragraphs in this chapter.

The dedicated HP 8510 versions (HP 

 

 of the

HP 8360 series cannot be used with the HP 

Refer to “Leveling with MM-wave Source Modules,” in Chapter 1 for

information and examples.

Connections from the HP 8360 series to the HP 

 noise figure

meter are identical to those used with the HP 

 Configure

the HP 8360 series to an address corresponding to the source address
of the HP 8970, typically HP-IB address 19, and network analyzer
language.