NEC ES SlimLine Series Dépliant

■

Maximum memory supported: 512 MB; 
minimum memory required: 32 MB.

■

Memory type and size can vary between sockets.

■

System supports 168-pin, 100-MHz non-ECC SDRAM modules 
in 32-MB, 64-MB, 128-MB, and 256-MB configurations.
Use NEC memory upgrade kits for the best compatibility with your
system. For memory compatibility information, call Technical Support.

■

Single- or double-sided DIMMS are supported.

■

No jumper setting required.

409-00065-000

Note: See your PowerMate ES SlimLine Series User’s
Guide for detailed option installation information.

See your user’s guide for detailed processor upgrade information.

Factory setting. Sets the system for 

normal operation. The BIOS uses current 
configuration information and passwords 
at power on.

To enable BIOS recovery for a corrupted 
system, remove the jumper. Wait 10 seconds.
Replace the jumper on pins 1 and 2.

Restores Safe BIOS settings as the 
default BIOS settings and loads the 
BIOS Setup at power on.

1 2 3

1 2 3

Factory setting. 

Uses an Intel

®

CPU.

3
2

1

Uses a Cyrix

®

CPU.

3
2

1

Factory setting. Maintains system board 

configuration in CMOS RAM 
with onboard battery.

Clears CMOS while system power is off.  
Return jumper to pins 1 and 2 before 
powering system on.

Caution: To prevent damage to the system board,

avoid clearing CMOS while power is on.

3
2

1

3
2

1

Factory setting. Wakes up the system from 

Suspend to RAM mode via the keyboard. 
Requires Windows 98 running in Advanced 
Configuration Power Interface (ACPI) mode.

Normal operation. 
Disables Keyboard Wakeup.

3 2 1

3 2 1

Factory setting. Enables onboard audio.

Disables onboard audio. Use this 
setting if you install a sound card.

1 2 3

1 2 3

Factory setting. Enables the

Save to RAM function.

Disables the Save to RAM function.

409-00065-000  4/19/00 3:01 PM  Page 1