Hatco GRN Manuale Utente

Form No. GRM-0707

INSTALLATION

Figure 16. Adjustable Angle Bracket Mounting

UNDERSHELF MOUNTING

Pass Thru
NOTE: When mounting the unit under a shelf, it is
recommended to use a remote switch enclosure.

If the shelf has a rolled or flanged edge, use the
optional adjustable angle brackets to mount the unit
below the lowest part of the rolled or flanged edge.
(See Figure 16.)

NOTE: GRN Series units are supplied with matching
Designer colored angle brackets providing 1-1/2"
(38 mm) clearance between foodwarmer and
overshelf.

CAUTION

To assure safe and proper operation refer to
Installation Clearance Requirements listed in
this manual.

Adjustable Angle Bracket Mounting
NOTE: When mounting the unit under a shelf it is
recommended to use a remote control enclosure.

NOTE: Multiple brackets will be needed for dual
units.

1. Position the Glo-Ray unit on a flat surface with

the heating element facing down.

2. Remove the two screws and mounting tabs from

each end of the Glo-Ray unit.

3. Remove the two upper end plate screws.

4. Align the adjustable angle bracket to the end

plate mounting holes of the Glo-Ray unit. Secure
angle bracket with previously removed screws.

5. Fasten angle bracket to the underside of the

shelf using appropriate fasteners. (Not supplied
by Hatco.)

Hanger Tab Mounting
The standard mounting tabs supplied with the unit
can be bent 90° for mounting the unit underneath a
shelf without a rolled or flanged edge. (See Figure
17.)

Adjustable
Angle Bracket

Figure 17. Hanger Tab Mounting

Mounting Brackets bent 90°