Toshiba 431B Manuale Utente

4300 Series Ancillary Cabinets Installation and Operation Manual

13 Optional Kickplate Installation

Purpose

This Installation Guide shows how to correctly install the optional 4300 Series Kick Plates on the 4300 UPS, 431A

Ancillary Cabinet, and the 431B Battery Cabinet. These instructions are also available in the Manuals for the respec-

tive cabinets.

Toshiba International Corporation reserves the right, without prior notice, to update information, make product changes,

or discontinue any product or service identified in this publication.
Toshiba International Corporation shall not be liable for direct, indirect, special, or consequential damages resulting

from the use of the information contained within this Installation Guide.

Box Contents

Part Number

4300-30/50-KP-A

4300-30/50-KP-B

Instruction Sheet (P/N 66597)

F/B (Front/Back) Kick Plate, 22 in.

Side Kick Plate, 30.5 in.

(None)

NOTES

Initial set of kick plates to

enclose the base of one

4300 cabinet.

Add-on kick plates to enclose ad-

ditional cabinets. The sides are

moved to the outer sides outermost

cabinets in the lineup.

Both pair of kick plates are symmetrical - there is no upside

down.

Tools Required

None - The kick plates consist of the F/B panels that magnetically latch to the welded base of the 4300 Series cabi-

nets and a second pair (sides) that magnetically latch to the F/B plates.

Installing 4300-30/50-KP-A

NOTE: Due to variations within manufacturing specifications, the spacing on the base channels may be

slightly more or less than the separation between the magnetic

latches of the kick plates.
To correct this the installer should bend the magnetic latch support

tab slightly to ensure a snug fit to the base channels.

STEP 1: Fit the F/B Plates with the UPS C-channel

skids.

1.1 Place a F/B kick plate on edge on the floor, magnetic latches side

toward the UPS with the magnetic latch faces facing left. See Figure 13-1.

1.2 Place one in front and one at the back of the UPS.
1.3 Slide the front F/B kick plate forward until both magnet latches adhere

to the left and right vertical C-channel base skid member.

1.4 If one of the magnets does not latch firmly, or the spacing is too nar-

row, bend one or the other of the magnetic latch supports in or out as

required to ensure a good fit. See Figure 13-1.

1.5 Repeat Step 13-3 and 13-4 for the F/B kick plate at the back of the

UPS.

1.6 Remove the F/B kick plates from the C-channel base skids.

Left Base Skid

Figure 13-1

Right Base Skid