Netopia R2020 Manuale Utente

To go to the IP Address Ser ving screen, select IP Address Serving in the System Configuration screen and 
press Return.

Follow these steps to configure IP Address Ser ving:

■

If you enabled IP Address Ser ving either by using Smar tStar t or in Easy Setup, DHCP, BootP clients, 
Dynamic WAN clients, and MacIP/KIP clients (if you have the AppleTalk kit installed) are automatically 
enabled.

■

Select Number of Client IP Addresses and enter the total number of contiguous IP addresses that the 
Netopia R2020 will distribute to the client machines on your local area network.

■

In the screen example shown above, five Client IP addresses have been allocated.

■

Select 1st Client Address and enter the first client IP address that you will allocate to your first client 
machine. For instance, on your local area network you may first want to figure out what machines are going 
to be allocated specific static IP addresses so that you can determine the pool of IP addresses that you will 
be ser ving addresses from via DHCP, BOOTP, Dynamic WAN, and/or MacIP.

■

Example: Your ISP has given your Netopia R2020 the IP address 192.168.6.137, with a subnet mask of 
255.255.255.248. The subnet mask allocated will give you six IP addresses to use when connecting to the 
ISP over the Internet (for more information on understanding IP addressing refer to 

). Your address range will be from .137-.143. In this example you would 

enter 192.168.6.138 as the 1st client address, as the router itself must have an IP address.

■

To enable DHCP, select Serve DHCP Clients and toggle it to Yes. DHCP ser ving is automatic when IP 
Address Ser ving is enabled.

                              IP Address Serving

         Number of Client IP Addresses:     5
         1st Client Address:                192.168.6.138
         Client Default Gateway...          192.168.6.137

         Serve DHCP Clients:                Yes
         DHCP NetBios Options...

         Serve BOOTP Clients:               Yes

         Serve Dynamic WAN Clients          Yes

         Serve MacIP/KIP Clients:           Yes
         MacIP/KIP Static Options...

Enter the maximum number of dynamic IP clients to support.
Configure Address Serving (DHCP, BOOTP, etc.) here.