RAD Data comm Modular Access Device with Integrated Router Manuale Utente

FCD-IPM Installation and Operation Manual 

Chapter 5  Setup Menu 

 

Interface Parameters Menu 

5-63 

for E1 links 

Select this parameter to specify the E signal receive mode from E1 into E&M. The 
values are: 

 

When the received A bit signal from E1 equals 1 then the E signal will be 

activated in the E&M interface 
When the received A bit signal from E1 equals 0 then the E signal will be 

inactivated in the E&M interface 

When the received A bit signal from E1 equals 0 then the E signal will be 
activated in the E&M interface 

When the received A bit signal from E1 equals 1 then the E signal will be 

inactivated in the E&M interface 

When the received B bit signal from E1 equals 1 then the E signal will be 

activated in the E&M interface 

When the received B bit signal from E1 equals 0 then the E signal will be 

inactivated in the E&M interface 

When the received B bit signal from E1 equals 0 then the E signal will be 

activated in the E&M interface 

When the received B bit signal from E1 equals 1 then the E signal will be 
inactivated in the E&M interface. 

This parameter specifies the default signaling bits that are not used for the 
M signal. Those bits will be transmitted towards E1. 

This parameter specifies the E signaling state in E&M when an Out of Service 
condition is indicated in the E1 link. The values are: 

E1 signal is held at inactive for the duration of the Out of Service condition 

E1 signal is held at active for the duration of the Out of Service condition 

E1 signal is held at inactive for 2.5 seconds, and then toggled to active 
until the Out of Service condition end 

E1 signal is held at active for 2.5 seconds, and then toggled to inactive 

until the Out of Service condition end. 

Refer to 

A typical screen is shown in